If you have been reading about lyophilization and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2026-03-28. Where a claim depends on a specific study, the study is described rather than over-claimed.
The sequence places several glycine and proline residues near the middle, which may influence how the chain folds in solution. The peptide is linear rather than cyclic, and it carries no disulfide bridges. Commercial material is commonly supplied as the acetate salt, although the free base and other counterion forms also appear. Because the term BPC-157 refers to a specific sequence, samples with slight sequence variants are chemically different substances. Published work generally treats the fifteen-residue sequence as the defining structure.
Physical descriptions in supplier documents and papers usually list the compound as a white to off-white powder. It dissolves readily in water and in common aqueous buffers, and solutions are often prepared fresh before an experiment. Molecular mass near 1419 daltons helps verify identity during mass spectrometry. The powder is somewhat hygroscopic, so moisture exposure can alter the measured mass of a sample. Purity is typically reported as a percentage from chromatographic analysis.
Lyophilized peptide powder is generally stored at minus twenty degrees Celsius or lower and kept away from light and moisture. Under these conditions degradation is slow, and sealed vials remain stable for extended periods. Once dissolved, the material is less stable, particularly in aqueous buffers near neutral pH, where hydrolysis and oxidation proceed faster. Solutions are usually kept cold and used within days to weeks. Repeated freeze-thaw cycles are avoided because they encourage aggregation.
Identity and purity are established using reversed-phase high-performance liquid chromatography, which separates the peptide from related impurities and yields a percentage purity. Mass spectrometry, typically with electrospray ionization, confirms the molecular mass against the expected value. Amino acid analysis or peptide mapping provides additional sequence confirmation. These methods are complementary, since chromatography measures how much material is present while mass spectrometry verifies what that material is. A certificate of analysis normally reports both.
Analytical results depend on the column, gradient, and detector wavelength chosen by the laboratory, so purity values from different sources are not always directly comparable. Water content, counterion form, and residual trifluoroacetate affect both mass and purity calculations. Microbiological and endotoxin testing are separate from chemical purity and are not covered by a standard chromatographic run. Buyers evaluating a material typically request the full method description rather than a single purity figure.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C62H98N16O22 | Approximate, for sequence GEPPPGKPADDAGLV |
| Molecular mass | ~1419 Da | Neutral form |
| Appearance | White to off-white powder | Lyophilized solid |
| Solubility | Soluble in water | Also soluble in aqueous buffers |
| Typical storage | -20 C | Dry powder, protected from moisture |
BPC-157 is normally distributed as a lyophilised powder that ranges from white to off-white in appearance. The peptide dissolves readily in water, normal saline, and common aqueous buffers, and it is poorly soluble in nonpolar solvents such as hexane or vegetable oils. Lyophilised vials take up moisture if left open, which changes the mass of powder in the container and complicates any later weighing. Because the material is handled in small quantities, static and adhesion to glass or plastic can also cause noticeable losses during transfer.
The main chemical liabilities of this sequence are peptide-bond hydrolysis and possible aspartate-related reactions, since the peptide contains aspartic acid residues but no cysteine, methionine, or tryptophan. Absence of those three residues removes the most common oxidation and disulfide pathways from consideration. Studies of related peptides indicate that aspartate isomerisation and aspartimide formation occur most readily at Asp-Gly and Asp-Ala positions, and open questions remain about how quickly those reactions proceed under ordinary laboratory conditions. Storage guidance typically emphasises cool, dry, dark conditions to slow hydrolysis.
Identity and purity are usually assessed with reversed-phase high-performance liquid chromatography, often paired with mass spectrometry using electrospray or MALDI ionisation. Amino acid analysis and peptide mapping by enzymatic digestion provide additional sequence-level confirmation. Purity is commonly reported as an area percentage from a chromatographic trace, and water content can be measured by Karl Fischer titration. Reported masses may differ by tens of daltons between sources because preparations can contain acetate or trifluoroacetate counterions, and such differences are not by themselves evidence of a different peptide.
BPC-157 is a synthetic peptide built from fifteen amino acid residues. Its sequence comes from a larger protein fragment that researchers isolated from human gastric juice and described as a body protection compound. The fragment contains glycine, glutamic acid, five prolines, lysine, alanine, two aspartic acids, leucine, and valine. The number 157 in the name refers to the position of the stretch within the parent protein. Material used in laboratories is manufactured rather than extracted from stomach fluid.
The molecule carries 15 residues, a molar mass near 1419.5 g/mol, and the formula C62H98N16O22. Its structure features a proline-rich central region, a pair of adjacent aspartic acid residues, and no cysteine. The absence of cysteine means no disulfide bonds can form, which simplifies refolding and reconstitution. Suppliers usually ship the material as a freeze-dried powder that appears white to off-white. It dissolves readily in water and in saline solutions.
== Discovery == Studies conducted in the 1970s found that a series of N-formylmethionine-containing oligopeptides, including the most potent and best known member of this series, N-formylmethionine-leucyl-phenylalanine (fMLF or fMet-Leu-Phe), stimulated rabbit and human neutrophils by an apparent receptor-dependent mechanism to migrate in a directional pattern in classical laboratory assays of chemotaxis. Since these oligopeptides were produced by bacteria or synthetic analogs of such products, it was suggested that the N-formyl oligopeptides are important chemotactic factors and their receptors are important chemotactic factor receptors that act respectively as signaling and signal-recognizing elements to initiate inflammation responses in order to defend against bacterial invasion. Further studies defined a receptor for the N-formyl oligopeptides, formyl peptide receptor (FPR), so named based on its ability to bind and become activated by the oligopeptides. Two receptors where thereafter discovered and named FPR1 and FPR2 based on the similarity of their genes' predicted amino acid sequence to that of FPR rather than on any ability to bind or be activated by the formyl oligopeptides.
== Food preservation additive == Ascorbic acid and some of its salts and esters are common additives added to foods such as canned fruits, mostly to slow oxidation and enzymatic browning. It may be used as a flour treatment agent used in breadmaking. As food additives, they are assigned E numbers, with safety assessment and approval the responsibility of the European Food Safety Authority. The relevant E numbers are:
== History == Doxepin was discovered in Germany in 1963 and was introduced in the United States as an antidepressant in 1969. It was subsequently approved at very low doses in the United States for the treatment of insomnia in 2010.
Sources: en.wikipedia.org
Somatostatin is a G protein-coupled receptor ligand. When the receptors are activated, it causes the cells where the receptors are expressed to decrease hormone secretion. Mainly, as a neuroendocrine inhibitor, it exerts its effects on gastrointestinal (GI) tract, pancreas, hypothalamus, and central nervous system (CNS), causing hormone secretions coupled to this pathway to be reduced. It can affect neurotransmission and memory formation within the central nervous system. Within human and animal models, it demonstrated its effects of preventing angiogenesis and reducing healthy and cancer cell proliferation. Within tumors, somatostatin receptors, mostly of the ssrt2 subtype, are expressed in most neuroendocrine tumors, breast tumors, some brain tumors, renal cell tumors, lymphomas and prostate tumors.
=== Fusexin === The fusexin family consists of eukaryotic HAP2/GCS1, eukaryotic EFF-1, viral "class II", and haloarchaeal Fsx1. They all share a common fold and fuse membranes. In an unrooted phylogenetic tree from 2021, HAP2/GCS1 and EFF-1/AFF-1 occupy two ends of the tree, the middle being occupied by viral sequences; this suggests that they may have been acquired separately. The latest structure-based unrooted phylogenetic tree of Brukman et al. (2022), which takes into account the newly-discovered archaeal sequences, shows that Fsx1 groups with HAP2/GCS1, and that they are separated from EFF-1 by a number of viral sequences. Based on where the root is placed, a number of different hypotheses regarding the history of these families – their horizontal transfer and vertical inheritance – can be generated. Older comparisons excluding archaeal sequences would strongly favor an interpretation where HAP2/GCS1 is acquired from a virus, but the grouping of Fsx1 with HAP2/GCS1 has allowed the possibility of a much more ancient source.
3-D Viewer of a male American mastodon skeleton, with bones labelled, at the University of Michigan Mammutidae digital fossil repository Interactive views of various primate skeletons at eSkeletons.org (associated with the University of Texas at Austin)
Sources: en.wikipedia.org
The letters BPC stand for body protection compound. The number 157 refers to a specific fragment designation from early work on gastric proteins. The full name is a label for a synthetic fifteen-amino-acid peptide rather than a naturally isolated drug.
No. The gastric protein is larger, while BPC-157 is a short fragment sequence. The peptide is produced synthetically for research use. The relationship is one of sequence origin, not chemical identity.
It is most often supplied as a lyophilized powder, frequently as the acetate salt. The powder is reconstituted with water or a buffer before use. Free-base and other salt forms also exist but are less common in catalogs.
Bacteriostatic water or sterile saline is commonly used to dissolve the powder. The choice of solvent affects stability and preservation. Aqueous solutions are kept refrigerated and are not intended for long-term storage.